All new 14 gauge speaker wire was run to the door speakers instead of using factory wiring, to ensure a clean signal from the amplifier to the speakers. RCAs were run from the JVC receiver along the passenger side of the vehicle. Power cables then split off to the Picasso Nano PN4.520D and MTX powered subwoofer. Wiring was installed carefully, making sure power wire and RCAs did not cross paths – power wire was run from the driver’s side (where the battery is on 2007 Toyota Highlander) to a distribution block installed under the driver’s seat. For the low end, without sacrificing much space (which a mother of 2 needs for cargo), we added the 8″ MTX Audio RT8PT Universal Powered Subwoofer.
#Soundstream pn4 520d series#
We upgraded her front door speakers to Kenwood Kfc-P709Ps 6.5-Inch Performance Series Component Speaker System and rear doors with Kenwood 6.5″ coaxial speakers for rear fill. We paired our Soundstream PN4.520D to a JVC KW-HDR81BT CD receiver with 2.5v RCA outs. There is no need for higher signal to noise ratio when the volume on your receiver is at the minimum and the amplifier isn’t being called on to put out any power. Amplifier signal to noise ratio greatly improves when more of its power output is in use.
#Soundstream pn4 520d full#
Soundstream measured it at 1w, not full power. Note: The signal to noise rating looks low, but don’t be discouraged by that.
#Soundstream pn4 520d manual#
The following link is for the official manual with more specs for those interested. On that note, this amp does not run hot – even after 30+ minutes of high volume play the surface is comfortable to the touch.
We installed ours underneath the front passenger seat, with plenty of clearance between the amp and seat for ventilation. These dimensions make it useful for stealth installations. This amplifier weighs in at a lite 3.97 lbs (1.8 kg) with exceptional dimensions for the power and quality of output: 4.75″ x 9″ x 1.5″. This amplifier also has low and high pass filters locked at 80 Hz (12dB/octave) or can be set to “full range” mode with no filter. Who says size doesn’t matter? Well, they’re wrong! Yes, the motion of the ocean, or in this case, the sound of the stream, is very important, but if you want a car audio amplifier that puts out plenty of power while being in a small enough package to fit almost anywhere in a vehicle, the Soundstream PN4.520D is the way to go! When I was looking for an amplifier to drive the component speakers in my wife’s SUV, the big power but small size of this sexy black beauty fit the bill!Ĥ-channel class D amplifier: 100 watts RMS x 4 at 4 ohms 130 watts RMS x 4 at 2 ohms 260 watts RMS x 2 bridged at 4 ohms.
0 kommentar(er)
